One for Top to bottom polarization and the other for Horizontal polarization Along with the extra efficiency of four full quad elements the L4 comes the capability to effortlessly up grade the antenna to 6 components (switching it into our L6 design).If area or a restricted budget presently helps prevent you from buying our L6, the D4 offers room to update.Exceptional SFS (Transmission Feed Program, trademarked) matching system gives maximum directional functionality and dual polarity to enable switching between close up (nearby) and lengthy haul transmission pathways (DX) Use it as Basé-to-Mobile Switch to Top to bottom Polarization and extends the helpful variety of a bottom station many times over.
Cubical Quad Antenna Gain Free Connections WithSignals off the sides and back again are greatly reduced, permitting interference-free connections with mobiles over great distances.
Cubical Quad Antenna Gain Full Quad ElementsBrings in channels that cannot be noticed on an omni or smaller beam. Use it as Basé-to-Base AIl of the basé-to-mobile benefits described above plus the ability to switch to side to side (toned side) polarization to additional minimize disturbance from local stations. Under appropriate receiving circumstances channels from all 50 expresses and various other nations can become copied. Outstanding Features Directivity Extremely high front-to-báck and front-tó-side ratios. If you have a 100 ohm feedpoint impedance, that will create it near to 100 ohms at the tuner, which should end up being pretty simple to go with. Nevertheless at the Antenna give food to point Is definitely WHERE I AM UNCERTAIN exactly what to do. Should I just link the 450 Ohm range straight to the Quad motivated element, Or even would it be much better to have got a 4:1 Balun balbal there. Many Quad. Antennas present approx. Ohms or therefore at the desired feed stage. ![]() An simple job with coax, more complicated with ladder or open wire line. Mike AF7ON. Actually coax will not need a 1:1 choke balun, although it doesnt hurt to use one. I would use whatever length of 300 ohm ladder range physically matches. ![]() If you had an unusual QW size of feedline, after that the impedance introduced to the tuner would become around 2000 ohms, assuming 450 ohm range. This may become tough for the tuner to match up, or also become out of range of the tuner, based on the specific frequency. The specifications for the tuner present 2500 ohm maximum on 160-20M, but 1000 ohms potential on 17-10M. Cubical Quad Antenna Gain Series Would MakeChanging to 300 ohm series would make the complement much better, with 900 ohms being the result of a 100 ohm antenna and a QW feedline. Mmm yep, three hundreds Ohms lines at 12 wavelength line lengths( or multiples of 12 influx) can be on the plank.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |